Tuplex Underlay

Upofloor Tuplex is a new-generation underlay for hardwood flooring. Tuplex is made out of two layers of solid polyethene with flexible polystyrene granules between the layers.

This structure makes Upofloor Tuplex a clean, durable and lightweight material that is easy to handle and install, even in confined spaces. Tuplex also provides a highly effective double moisture barrier against subfloor humidity, obviating in most cases, the need for a separate moisture barrier.

Specifications

Levels out subfloor
Flexible construction helps smooth out any minor irregularities of the subfloor, and provides an ideal base for hardwood flooring.

Ventilation
Tuplex’s granular composition creates space between the floorboards and the subfloor, allowing for efficient ventilation.

Moisture barrier
The two-ply polyethene film of Upofloor Tuplex makes it a highly effective double moisture barrier. In most cases, there is no need for a separate moisture barrier. A test report is available form the manufacturer.

Sound insulation
Tuplex underlay, combined with any commonly used intermediate floor construction, meets the requirements pertaining to impact sound insulation in intermediate floors. Because of its high flexibility and resilience, its sound insulation properties will never wear out. A test report is available from the manufacturer.

Easy Installation
Laying the hardwood flooring is one of the final phases of interior decoration. At this point the room is usually full of recently finished surfaces, which must be protected against dirt and dents. Upofloor Tuplex is a clean, durable lightweight material that is easy to handle and install, even in confined spaces.

Technical specifications

Width
1.1 m

Thickness
approx. 3 mm

Weight
136 g/m²

Roll length and area coverage
30 m, 33 m²
15 m, 16.5 m²

Roll weight
approx. 4.5 kg/30 m
approx. 2.25 kg/15 m

Installation

Before installation, make sure that the subfloor is clean, dry and level. The relative humidity of concrete floors must be under 85 %. Check that the floor surface is level with e.g. a ruler or a straight floorboard: - max 3 mm deviation allowed over a length of 2000 mm. Where necessary, level out the subfloor, using a good quality levelling compound.

Prior to installation, remove any dirt and dust form the subfloor. Roll out a strip of the underlay on top of the subfloor, leaving a narrow gap (appr. 5 mm) between the underlay and the wall.

Roll out more of the underlay, joining successive strips with butt-seams and sealing off with plastic tape, 5 cm minimum width.